A one-time solution has been approved for the project '146 Westchester Ave' to produce the louver with a width of 2608 mm, exceeding the allowed maximum width of 2456 mm.

 For the project '24563 Willets Point Building #2 - Adler Windows', tolerances for screw holes in the Epocha louver (Drawing ID-0000028-67.V1) were found to be too large, prompting a change from d3.9x16 mm screws to d.4,2-16mm.

 As a one-time solution for the project '18777 The Barnett' production has agreed to manufacture smaller louvers than typically allowed in the system: 5 units of 1363.2mm x 315.4mm and 4 units of 950.4mm x 315.4mm

 As a one-time solution for the project '20864 St. Clair Residences (36 Main St., Yonkers)' a new project-specific PTAC sleeve from SIMON-AIRE, requiring custom coordination for future use, has been added to the library

 As a one-time solution for the project '24563 Willets Point Building #2 - Adler Windows' a new project-specific louver has been developed. 

 8. 

 As a one-time solution for the project '19350 146-93 Guy R. Brewer Boulevard' it was allowed to produce 2 units of very low Louvers: 1117mmx150mm height. 

 As a one-time solution for the project '24650 Hilton Garden Inn - 1523 S Ridge Rd. Wichita KS', standard weep holes and a drain kit were approved, resulting in the need for modifications to the louver grills (drawing ID-0000028-103). 

 10.

 As a one-time solution for the project '23216 The Residences at Benning Road SE (Washington)', Intus Louver grills were modified to accommodate drain tubes by cutting a few blades and forming a hole in a specific location.

 As a one-time solution for the project '18771 Clarkson Estates,' the louvers were manufactured with full insulation, and the louver frame for the Supera 74 system was used in the Supera 83 frame.